|
Wear is a constant problem throughout the bulk
handling industry. We offer a complete range of materials which cover
the breadth of requirements for both abrasion resistance and flow assistance
The following products are available
Contact us now by Tel: +44 (0)1829 740913 or Fax: +44 (0)1829 740574 or by email.
|
Hardened Steel
Abrasion resistant, through hardened steel
plate. Available in sheet form or flame cut to your requirements. A
full range of thicknesses can be supplied, usually ex-stock. Hardness
400 and 500 HB average. |
|
Hard Faced Plate
Hard faced plate is a Chrome Carbide coating
deposited onto mild steel substrate. The thickness of the wear
resistant layer can be varied to suit your application. It is
available in sheet form or pre-cut shapes to fit into your application.
Suitable for chute linings, hammer mills and
wear edge protection. |
|
 |
Rubber Linings
Using rubber compounds that have been specially
formulated for maximum wear and impact resistance. Complex curves can
be covered with good adhesion. This results in long life and superb
abrasion resistance.
We can also supply steel backed rubber if you
require a bolt in solution, this can be pre-drilled or have studs
welded to the back. Just let us know the shapes you require! |
|
Ultra High Molecular
Weight Polyethylene
A highly inert and non absorbent material. UHMW
Polyethylene is a solid hard engineering plastic with considerable
advantages compared to other plastic materials. Available in virgin
and recycled grades. We can cut and machine to your requirements.
Hopper lining fitting service available should you require.
This range of materials is especially useful
for promoting flow in hoppers and chutes by discouraging rat-holing
and core flow. When compared to other chute linings, polyethylene can
improve the angle of friction by as much as 10 degrees! |
|
 |
Ceramic Linings
The ultimate in wear resistance. We can line
both flat chutes and complex curves including conical sections. The
alumina tiles used have a hardness of 900 which gives a life way in
excess of other materials. If this is still insufficient for your
application, we can cast with even harder materials. |
|
|
|
|
TOP OF PAGE |
